Publication :


Mechanical and thermo-physical properties of plasma sprayed thermal barrier coatings : a literature review

Authors: P. Planques, V. Vidal, P. Lours, V. Proton, F. Crabos, J. Huez and B. Viguier
Year: août 2017
Journal: Oxidation of Metals.
Volume: 88, Number: 1-2, Pages: 133-143

DOI: 10.1007/s11085-016-9693-1
Référencé ISI Web Of Science
Référencé Scopus

Atmospheric plasma-sprayed thermal barrier coatings (APS TBCs) have been studied from an extensive review of the dedicated literature. A large number of data have been collected and compared, versus deposition parameters and/or measurement methods, and a comparison was made between two different microstructures: standard APS coatings and segmented coatings. Discussion is focused on the large scattering of results reported in the literature even for a given and fixed fabrication procedure. This scattering strongly depends on the methods of measurement as expected, but also - for a given method - on the specific conditions implemented for the considered experimental investigation. Despite the important scattering, general trends for the correlation of properties to microstructure and process parameters can be derived. The failure modes of TBC systems were approached through the evolution of cracking and spalling at various life fractions.

Bibtex citation :
Author={Planques, P. and Vidal, V. and Lours, P. and Proton, V. and Crabos, F. and Huez, J. and Viguier, B.},
Title={Mechanical and thermo-physical properties of plasma sprayed thermal barrier coatings : a literature review},
Journal={Oxidation of Metals},

INSTITUT CLEMENT ADER, 3, rue Caroline Aigle F-31400 Toulouse, France.
Livraisons : +33 (0)5 61 17 10 07
Secrétariat ICA: +33 (0)5 61 17 10 85 ou +33 (0)5 61 17 10 82
Fax : +33 (0)5 61 17 10 80