Publication :


Title:

Drilling of thick composite materials using a step gundrill

Authors: P. Rahme, Y. Landon, F. Lachaud, R. Piquet and P. Lagarrigue
Year: 2017
Journal: Composites Part - A: Applied Science and Manufacturing.
Volume: 103, Pages: 304-313

DOI: https://doi.org/10.1016/j.compositesa.2017.10.016
Référencé ISI Web Of Science
Référencé Scopus

Abstract:
The assembly of aeronautical parts requires the machining of composite materials. Drilling is the most important process in the assembly. When drilling composite materials, a number of defects are generating. A solution, to reduce these defects, is to drill using a step gundrill. In this paper, drilling of thick composite plates using a step gundrill is studied. Delamination, which is considered the major drilling defect, is analytically modelled at the hole exit. The critical thrust force at delamination is then found dividing the plate under the tool into several zones corresponding to the tool active part. These results are experimentally validated. The optimal cutting conditions at delamination are finally determined using a cutting force model. This model uses the same zones decomposition as the analytical critical thrust force model. The results of this paper can be extended to other tools to find the optimal cutting conditions corresponding for delamination-free drilling.

Bibtex citation :
@article{Rahme2017,
Author={Rahme, P. and Landon, Y. and Lachaud, F. and Piquet, R. and Lagarrigue, P.},
Title={Drilling of thick composite materials using a step gundrill},
Journal={Composites Part - A: Applied Science and Manufacturing},
Volume={103},
Number={},
Pages={304-313},
Year={2017}}


INSTITUT CLEMENT ADER, 3, rue Caroline Aigle F-31400 Toulouse, France.
Livraisons : +33 (0)5 61 17 10 07
Secrétariat ICA: +33 (0)5 61 17 10 85 ou +33 (0)5 61 17 10 82
Fax : +33 (0)5 61 17 10 80